大家好 最近剛接觸這塊tms320c5535 ezdsp 開發版
執行 UART範例程式時 TERMINAL端都沒任何回應,其中一種是CCS v4 提供的
另外想確認的是PORT是選J2 USB接口是嗎?
也試過連接P2接口上的38 40腳直接接一個UART轉USB的模塊,終端機一樣沒回應,應該只需要接上TX RX兩隻腳就可以了吧? RTS與CTS應該不需要接上吧?
板子上的切換開關(SW3)沒有變更過。
請大家幫我解惑一下,感謝
程式如下:
Int16 uart_test()
{
char rx;
/* Enable UART to FTDI chip */
EZDSP5535_GPIO_init();
EZDSP5535_GPIO_setDirection( 15, GPIO_OUT ); /
EZDSP5535_GPIO_setOutput( 15, 0 );
printf(" This program tests the UART over the FTDI chip.\n");
printf(" Open a Terminal window set to 115200 baud.\n");
printf(" Type in the terminal and a message returns on the button pressed.\n");
printf(" Press escape to exit.\n");
/* Open Uart Handle */
EZDSP5535_UART_open( );
/* UART Test */
while(1)
{
/* Waitin for RX */
EVM5515_UART_getChar( &rx ); // Read 1 byte
// Was Esc pressed?
if(rx == 27)
break;
.
.
.